Figure 121. Removing a NVMe drive bay
Ne
xt steps
Replace the drive bay.
Installing a drive bay
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the drives.
4. Remove the drive from the drive backplane.
Steps
1. Insert the drive bay into the drive bay slot in the system.
2. Using the Phillips #2 screwdriver secure the drive bay to the system.
NOTE: The procedure to install the drive bays is similar for all configurations.
170 Installing and removing system components
To Next Page
Loading...
