Figure 127. Removing the optical drive
Ne
xt steps
Replace the optical drive or install the optical drive blank.
Installing the optical drive
Prerequisites
NOTE: Only slim 9.5-mm SATA DVD-ROM drive or DVD+/-RW drive can be installed in your system. External optical drives
c
an be connected through USB ports.
1. Follow the safety guidelines listed in S
afety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. If installed, remove the front bezel.
Steps
1. Align the optical drive with the slot on the system.
2. Slide the optical drive into the slot until the release tab clicks into place.
Installing and removing system components 175
To Next Page
Loading...
