3. If installed, r
emove the front bezel.
Steps
1. Open the release latch and slide the BOSS-N1 card carrier out of the BOSS-N1 module.
Figure 142. Removing the BOSS-N1 card carrier
2. U
sing the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1
card carrier.
3. Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Figure 143. Removing the M.2 NVMe SSD
4. I
f not installing the BOSS-N1 card carrier, align and push the BOSS-N1 card carrier blank into the BOSS-N1 module to fill the
empty BOSS-N1 card carrier slot.
Installing and removing system components 189
To Next Page
Loading...
