2. Slide out the BOSS-N1 module blank from the system using a flat head screwdriver.
Figure 140. Removing the BOSS-N1 module blank
3. A
lign the BOSS-N1 module to the BOSS-N1 slot on the chassis and push it into the slot.
4. Using a Phillips #2 screwdriver, secure the BOSS-N1 module to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 141. Installing the BOSS-N1 module
5. Connect the cables to the system board connectors.
NOTE: Route the cables properly to prevent them from being pinched or crimped.
Next steps
1. I
f removed, install the front bezel.
2. Install the air shroud.
3. Follow the procedure that is listed in After working inside your system.
Removing the BOSS-N1 card carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
188 Installing and removing system components
To Next Page
Loading...
