Figure 138. Removing the BOSS-N1 module
4. A
lign the blank with the BOSS-N1 module slot and push it into the bay until it clicks into place.
NOTE: Blanks must be installed in empty slots to maintain FCC certification of the system. The blanks also keep dust
a
nd dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 139. Installing the BOSS-N1 module blank
5. Using a Phillips #2 screwdriver, tighten the screw that secures the BOSS-N1 module blank to the system.
Next steps
Replace the BOSS-N1 module.
Installing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the air shroud.
4. If installed, remove the front bezel.
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the BOSS-N1 module blank from the system.
Installing and removing system components 187
To Next Page
Loading...
