Figure 137. Installing a memory module
Ne
xt steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
3. To verify that the memory module has been installed properly, press F2 during reboot and navigate to System Setup Main
Menu > System BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the
updated capacity of the installed memory.
4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. . Shut down the
system and ensure that the memory modules are firmly seated in the correct sockets.
5. Run the system memory test in system diagnostics.
Optional BOSS-N1 module
Removing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remove the air shroud.
4. If installed, remove the front bezel.
Steps
1. Disconnect the cables connected to the system board from the BOSS-N1 module.
2. Using a Phillips #2 screwdriver, remove the screw securing the BOSS-N1 module to the system.
3. Slide the BOSS-N1 module out of the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
186 Installing and removing system components
To Next Page
Loading...
