Figure 154. Installing the filler bracket
Ne
xt steps
Replace the expansion card.
Installing an expansion card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure that is listed in Before working inside your system .
3. Remo\ve the air shroud.
Steps
1. Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Open the expansion card latch adjacent to the slot you want to install the expansion card.
3. Remove the existing expansion card or filler bracket from the expansion card holder.
NOTE: Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain FCC
c
ertification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow
inside the system.
Installing and removing system components 203
To Next Page
Loading...
