Dell PowerEdge T560 - Page 235

CAUTION: T
ake care not to damage the system identification button while removing the system board
from the system.
CAUTION: D
o not lift the system board by holding a memory module, processor, or other components.
Steps
1. U
sing the system board holder and plunger, slide the system board towards the front of the system.
2. At a tilted angle, lift the system board out of the chassis.
Figure 195. Removing the system board
Ne
xt steps
1. Replace the system board.
Installing the system board
Prerequisites
NOTE: Before replacing the system board, replace the old iDRAC MAC address label on the Express Service Tag with the
iDRAC MAC address label of the replacement system board.
1. Follow the safety guidelines listed in the S
afety instructions.
2. Follow the procedure listed in Before working inside your system.
3. If you are replacing the system board, remove all the components that are listed in the removing the system board section.
Steps
1. Unpack the new system board assembly.
CAUTION: D
o not lift the system board by holding a memory module, processor, or other components.
Installing and removing system components 235