Figure 199. Installing the BOSS-N1 module blank
To
install the BOSS-N1 module:
1. To install the BOSS-N1 module , see Installing the BOSS-N1 card carrier steps 1 to 5.
NOTE: Refer to cable routing section, configuration 49 and 50 for more information on connecting the BOSS cables to
system board connectors.
NOTE: Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
242 Upgrade Kits
To Next Page
Loading...
