Table 144. Status LED indicators and descriptions (continued)
Icon Description Condition Corrective action
Memory indicator The indicator turns solid amber if a
me
mory error occurs.
Check the System Event Log or system messages
for the location of the failed memory. Reseat the
memory module.
If the problem persists, see the
Getting help section.
PCIe indicator The indicator turns solid amber if a
PC
Ie card experiences an error.
Restart the system. Update any required drivers for
the PCIe card. Reinstall the card.
If the problem persists, see the
Getting help section.
NOTE: For more information about the
s
upported PCIe cards, see the Expansion card
installation guidelines section.
System health and system ID indicator codes
The system health and system ID indicator is located on the left control panel of the system.
Table 145. System health and system ID indicator codes
System h
e
alth and system
ID indicator code
Condition
Solid blue Indicates that the system is powered on, is healthy, and system ID mode is not active. Press
the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID button to
switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists, see the Getting help
section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log for specific
error messages. For information about the event and error messages generated by the
system firmware and agents that monitor system components, go to qrl.dell.com > Look
Up > Error Code, type the error code, and then click Look it up.
iDRAC Quick Sync 2 indicator codes
iD
RAC Quick Sync 2 module (optional) is located on the left control panel front IO panel of the system.
250 System diagnostics and indicator codes
To Next Page
Loading...
