PowerVault (Dell MD1400) Setup Guide
Series 6 - R740xd (Hybrid)
The following figure shows Series 6 - R740 hybrid host (port 0) connected to PowerVault
(port 1 in top row of ports) using a mini-to-mini SAS cable.
The PERC H840 card for the R740 is installed in slot #4 inverted (upside down) in this slot.
This means that:
l Port 0 is on the right and port 1 is on the left on the R740.
l You must attach the cable to the R740 with the connector's blue tab on the bottom as
shown in the following picture.
l You must attach the other end the cable to the PowerVault with the connector's blue tab
on the top.
l You know if the cable is properly connected when you hear a click as the cable locks into
place and see the green port light illuminate on the R740.
Install PowerVault without Encryption 16
To Next Page
Loading...
