PowerVault (Dell MD1400) Setup Guide
5. To run the NwArrayConfig.py script using the default parameters, use one of the following
commands.
Caution: You must back up the Passphrase and retain this backup in a secure location. If
your PERC adapter hardware fails, you cannot recover any data on encrypted disks
without the Passphrase.
For RSA NetWitness Platform versions 11.2.0.0-1808301802.5.941817f or later, run the
following command:
./NwArrayConfig.py
[root@P<hostname> saTools]#
This script discovers all available PowerVaults; creates all the necessary virtual drives,
logical volumes, and the directory structure; and writes the debug messages to
/opt/rsa/saTools/arrayCfg.log. On (Network) Decoder hosts, this script adds the database
types of packetdb, metadb, and sessiondb. On Concentrator hosts, this script adds the
data.Nwbase types of metadb and sessiondb.
Install PowerVault with Encryption on a Series 6 R640 Host 36
To Next Page
Loading...
