PowerVault (Dell MD1400) Setup Guide
The following output and prompt is displayed.
Checksum type 'md5' disabled
The enclosure DELL MD1400 ID: 72 supports encryption, enable encryption for
this device y/n?
6. Type y and press Enter for encryption.
The following output and prompt is displayed.
This PERC adapter does not have a security key set.
Enter a Passphrase for the encryption key between 8 and 32 characters
in length,
with a mix of lower, upper and non-alphanumeric characters?
7. Type the <passphrase>, for example nFreDaW$792, and press Enter.
The following prompt is displayed.
Please re-enter passphrase again for validation?
8. Type the <passphrase> again, for example nFreDaW$792, and press Enter.
The following output and prompt is displayed.
Enter an optional ID string for the security key less than 256
characters or press Enter for none?
9. Press Enter if you do not want an optional ID string.
The following output and prompt is displayed.
*********************************************************************
*******************
The Passphrase for the security key *Must* be securely backed up in
case of PERC adapter
hardware failure, should this occur, data on all encrypted disks will
be unrecoverable.
Current
Passphrase
('Quoted'):
'<passphrase>'
Entered KeyID ('Quoted'): ''
*********************************************************************
*******************
Enter y to confirm that you backed up the Passphrase or press Enter
to cancel?
37 Install PowerVault with Encryption on a Series 6 R640 Host
To Next Page
Loading...
