PowerVault (Dell MD1400) Setup Guide
13. Type y and press Enter to enable encryption for this device.
Creating new volume group decodersmall2 on /dev/sde
Volume group "decodersmall2" successfully created
Creating new volume group decoder2 on /dev/sde
Volume group "decoder2" successfully created
Additional enclosures available! Rerunning to add additional storage
The enclosure DEL MD1400 ID: 73 supports encryption, enable
encryption for this device y/n?
Success!: Added all available storage found. The decoder service will
need to be restarted for the extended storage to be available.
14. Verify the results:
a. Make sure that the script did not produce any errors by viewing the
/opt/rsa/saTools/arrayCfg.log file:
more /opt/rsa/saTools/arrayCfg.log
b. Run the following command to verify the new sizes of the databases:
df -hP | grep 'decoder\|concentrator\|archiver\|Filesystem'
The following is an example of the results that are displayed for a Decoder:
39 Install PowerVault with Encryption on a Series 6 R640 Host
To Next Page
Loading...
