S5048F-ON switch installation
To install the S5048F-ON switch, complete the installation procedures in the order
presented in this section.
Always handle the switch and its components with care. Avoid dropping the switch or any
eld replaceable units (FRUs).
NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the switch and its components.
As with all electrical devices of this type, take all the necessary safety precautions
to prevent injury when installing this switch.
Topics:
• Unpack
• Rack or cabinet installation
• ReadyRails installation
• S5048F-ON switch installation
• Optics installation
• Switch power-up
• After switch installation
Unpack
NOTE
: Before unpacking the switch, inspect the container and immediately report
any evidence of damage.
When unpacking the S5048F-ON switch, make sure that the following items are included:
• One S5048F-ON switch
• One RJ-45 to DB-9 female cable
3
S5048F-ON switch installation 11
To Next Page
Loading...
Need help?
General