A
Appendix A: MIB and SNMP Trapsxxx | xxx109
Appendix A: MIB and SNMP Traps
The SCS has the ability to send audit events to an SNMP Manager. The SNMP
traps are defined in an SNMP Trap MIB.
The Trap MIB file may be uploaded from the SCS using the Save Trap MIB
function. The uploaded Trap MIB file may then be loaded into an SNMP Trap
Receiver application.
This appendix describes the trap events that may be generated by the SCS.
Although care has been taken to keep the information in this appendix up to
date, the actual Trap MIB file will contain the most accurate trap information.
An SNMP manager may access MIB-II objects of the SCS using the IPv4 or
IPv6 protocols.
By design, the enterprise specific MIB objects within the SCS cannot be
accessed using SNMP.
The SCS trap definitions use the structure described in the following Request
For Comments (RFCs).
• RFC-1155-SMI
Describes the common structures and identification scheme for the
definition of management information for use with TCP/IP-based
Internet.
• RFC-1212
Describes the format for producing concise and descriptive MIB
modules.
• RFC-1213-MIB
To Next Page
Loading...
