Dell Server Console Switch - Enabling or Disabling Scan Mode; Viewing and Disconnecting User Connections

54xxx | Local OSCAR User Interfacexxx
Enabling or Disabling Scan Mode
To start the Scan mode:
1 Activate the OSCAR interface and click Commands. The Commands
dialog box is displayed.
2 Select Scan Enable in the Commands dialog box. Scanning will begin.
3 Click X to close the Commands dialog box.
To cancel Scan mode:
Select a device if the OSCAR interface is open.
-or-
Move the mouse or press any key on the keyboard if the OSCAR interface is not
open. Scanning will stop at the currently selected device.
-or-
From the Commands dialog box, clear the Scan Enable checkbox.
Viewing and Disconnecting User Connections
You can view and disconnect users through the User Status dialog box. The
username (U) and server (S) will always be displayed when connected to a device
(local or remote). You can display either the device name or EID number to
which a user is connected. If there is no user currently connected to a channel,
the username and device fields will be blank.
To view current user connections, activate the OSCAR interface and click
Commands > User Status to open the User Status dialog box.
To disconnect a user:
1 On the User Status dialog box, click the letter corresponding to the user to
disconnect. The Disconnect dialog box will appear.
2 Click Disconnect to disconnect the user and return to the User Status
dialog box.
-or-