5. Disassembly and Assembly Procedures
S15
S13
No.2~9 screw size=M3x6, Torque=5±1kgfxcm)
(No.1 screw size=M4x8, Torque=5±1kgfxcm;
Use a Philips-head screwdriver to remove 9pcs
screws for unlocking power board and interface
board with the bracket.
Remove the circuit boards from the bracket chassis
module, and then disconnect all of the cables. Use a
Philips-head screwdriver to remove screws for 3pcs
unlocking TBT board with interface board.
(No.1~3 screw size=M3x6, Torque=5±1kgfxcm)
S20
7
9
6
8
2
4
5
3
1
S21
Lift up the middle frame and put it into a fixture, tear
off all the cable tape and the mylar tape for releasing
the LED key board away from the middle frame.
Tear off 2pcs shading tapes and 1pcs acetate tape,
and then disconnect the panel lamp cable from the
two connectors of the panel module.
Remove the mylar sheet from the hooks of the main
bracket chassis.
6
7
8
S14
To Next Page
Loading...
