1. Peel the tape that secures the battery cable to the system board.
2. Disconnect the battery cable from the system board.
3. Remove the four (M2x3) screws that secure the 4-cell battery to the palm-rest and keyboard assembly.
4. Lift the 4-cell battery, along with its cable, off the palm-rest and keyboard assembly.
Installing the 4-cell battery
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the 4-cell (54 Wh) battery and provides a visual representation of the installation
procedure.
Removing and installing components
19
To Next Page
Loading...
