1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system
board.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Network-port bracket
Removing the network-port bracket
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
The following image(s) indicate the location of the network-port bracket and provide a visual representation of the removal
procedure.
38
Removing and installing components
To Next Page
Loading...
