1. Peel the tape that secures the display cable to the system board.
2. Open the latch and disconnect the display cable from the system board.
3. Remove the three (M2.5x4.5) screws that secure the left-display hinge to the system board.
4. Remove the three (M2.5x4.5) screws that secure the right-display hinge to the system board.
5. Open the display hinges at an angle of 90 degrees.
6. Gently slide the palm-rest and keyboard assembly off the display assembly.
Installing the display assembly
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components
47
To Next Page
Loading...
