1. Remove the two (M2x5) screws that secure the network-port bracket to the I/O board.
2. Lift the network-port bracket off the I/O board.
Installing the network-port bracket
If you are replacing a component, remove the existing component before performing the installation process.
The following image(s) indicate the location of the network-port bracket and provide a visual representation of the installation
procedure.
1. Place the network-port bracket on the I/O board.
2. Align the screw holes on the network-port bracket to the screw holes on the I/O board.
Removing and installing components
39
To Next Page
Loading...
