1. Adhere the coin-cell battery to the slot on the palm-rest and keyboard assembly.
2. Connect the coin-cell battery cable to the I/O board.
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Heat sink
Removing the heatsink
1. Follow the procedure in Before working inside your computer.
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
2. Remove the base cover.
The following images indicate the location of the heatsink and provide a visual representation of the removal procedure.
36
Removing and installing components
To Next Page
Loading...
