1. Remove the screw (M2x3) that secures the solid-state drive thermal shield and the solid-state drive to the palm-rest and
keyboard assembly.
2. Slide and lift the solid-state drive thermal shield off the solid-state drive.
3. Slide and remove the solid-state drive from the M.2 slot two.
Installing the 2230 solid-state drive in M.2 slot two
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
NOTE: M.2 slot two supports only 2230 solid-state drive.
NOTE: This procedure applies only to computers shipped with a 2230 solid-state drive installed in M.2 slot two.
Removing and installing components 29
To Next Page
Loading...
