Steps
1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system board.
3. Replace the mylar cover back.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
Removing the heat sink - discrete
Prerequisites
NOTE: The heat sink type in your computer varies depending on the configuration ordered.
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
Disassembly and reassembly
37
To Next Page
