About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Figure 42. Removing the display assembly
Steps
1. Loosen the three captive screws (M1.6x2) that secure the display cable bracket to the system board.
2. Lift the display cable bracket off the system board.
3. Disconnect the camera cable from the camera cable connector (JCAM1) on the system board.
4. Disconnect the display cable from the display cable connector (JEDP1) on the system board.
5. Remove the three screws (M1.6x2.5) that secure the camera and display cable holder to the system board.
60
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
