6. Open the display to a 90-degree angle and place the computer at the edge of a flat table.
Figure 43. Open display to 90-degree angle
NOTE: Ensure to maintain the angle throughout the removal process to minimize the risk of damaging the thin display
panel when applying torque to install and remove screws from the computer.
7. Remove the three screws (M2.5x5) that secure the left hinge to the system board and the palm-rest and keyboard
assembly.
8. Remove the three screws (M2.5x5) that secure the right hinge to the system board and the palm-rest and keyboard
assembly.
9. Lift the display assembly off the palm-rest and keyboard assembly.
10. After performing all the above steps, you are left with the display assembly.
Removing and installing Field Replaceable Units (FRUs)
61
To Next Page
Loading...
