Enough of this reading stuff – I want to melt something!
For those of you who can‟t wait, here is a brief guide to get you up and running. It is
strongly recommended that you do take time to look over the controller instructions as
soon a possible.
Quick Start Guide:
Plug the Kiln in to an appropriate outlet and turn it on using the toggle switch on
the side of the control box.
The display will first indicate 88.88 for about five seconds, then indicates the
firing configuration that the controller is in (-90-. -96-, bEAd, CLA, or USR) for about 10
seconds. The display then alternates between the internal kiln temperature and IdLE.
If you need to change the firing mode;
o Press and hold the (increase) button until the LED display shows CFG.
o Press the (Program) button to display the current firing configuration.
o Press the (Increase) button to move to the correct firing configuration,
o (-90-. -96-, bEAd, CLA, or USR)
o Press the (Program) button to select the desired configuration – The display will
return to the IdLE / Temp indication.
To select the firing program;
Press the (Program) button to display the current firing program.
Press the (Increase) button to scroll to the desired firing program for your project.
(FUSE, tAC, SLP, POL, or user programs PR01 – 04.
Press the (Decrease) button to select the desired program. The small LED
beside “Review” will light, and the LED display will show rA 1.
You may either manually review the firing program, or simply do nothing and the
controller will automatically do a rapid step through for you.
Once the review has been completed, the display will show Strt.
Press the (Program) button and the kiln will display –On- and begin the firing
program.
If you need to stop the program, press the (Program) button again, the kiln will
shut down, and the display will show Stop.
Once the kiln has completed a firing program, it will shut down and display CPLt,
alternating with the kiln temperature and total program time.
DON‟T BE TEMPTED – DO NOT open the kiln until the display indicates that the kiln
has reached room temperature!
To Next Page
Loading...
Need help?
General
