SAFETY FIRST
Read and understand all operating instructions before operating your kiln.
SAFETY PRECAUTIONS: Kilns are as safe as any other electrical appliance when
used under normal and proper operating conditions. All safety precautions throughout
this manual should be observed.
o Use common sense while installing and using this kiln.
o Do not install kiln closer than 12" from any surface, or closer than 18” from a
combustible surface. Remove all potentially combustible materials from the kiln
area
o Make sure all electrical specifications are followed. Use correct voltage, wire
size and circuit breaker. Make sure all connections are tight. Avoid using
aluminum wire. Always use the proper grounded receptacle. A qualified
electrician or service person should be used for all electrical service or repairs.
o Install in covered, walled in, well-ventilated area. Do not allow your kiln to get
wet. Fumes from the ware should be vented to the outside. Never use your kiln
outside! Avoid moisture.
o Always keep children and unsupervised personnel away. Surface will get hot and
a burn could result.
o Fire glass only to the manufacturers recommended firing temperature. Improper
fire temperatures could result in damage to your kiln. Do not operate kiln over the
maximum temperature rating of 1700
o
F.
o Replace any worn or defective parts with ONLY genuine Jen-Ken Kiln
replacement parts.
o Unplug the kiln before servicing or vacuuming.
o Do not drop or slam the lid shut.
o Let the kiln cool to room temperature before opening the lid.
o NOTE: If you are in doubt about anything, call Delphi Glass 800.248.2048 or
Jen-Ken Kilns during regular business hours at 800.329.KILN.
To Next Page
Loading...
Need help?
General
