The preset 90 COE programs can be edited. Each program segment can be
changed by the operator. To restore the factory values, enter a zero value for the
first rA1 segment of each program and press the Program button.
In addition to the 90 COE preset programs, the -90- mode provides 4 User
defined programs for custom firing schedules. Each user defined program can be
up to 8 steps. The User programs are;
Program Rate Temp Hold
PrO1 Undefined Undefined Undefined
PrO2 Undefined Undefined Undefined
PrO3 Undefined Undefined Undefined
PrO4 Undefined Undefined Undefined
-96- Program Mode
The 96 COE mode provides 4 preset firing schedules for glass forming and 4
optional User Programs for creating custom firing schedules. The 4 preset
programs are recommended firing schedules that can also be customized if
necessary. These programs provide the various heating and cooling steps for
easy selection.
Full Fuse Displayed as FUSE
This program heats at 300F/hour to 1220F and holds this temperature for 30
minutes. Then heats at 600F/hour to 1465F and holds this temperature for 10
minutes. Then cools rapidly to 960F and holds this temperature for 40 minutes.
Then cools at 100F/hour to 800F and shuts off.
Tack Fuse Displayed as tAC
This program heats at 300F/hour to 1250F and holds this temperature for 30
minutes. Then heats at 400F/hour to 1310F and holds this temperature for 10
minutes. Then cools rapidly to 960F and holds this temperature for 60 minutes.
Then cools at 100F/hour to 800F and shuts off.
Slump Displayed as SLP
This program heats at 300F/hour to 1250F and holds this temperature for 15
minutes. Then cools rapidly to 960F and holds this temperature for 60 minutes.
Then cools at 150F/hour to 800F and shuts off.
Fire Polish Displayed as POL
To Next Page
Loading...
Need help?
General
