This program heats at 400F/hour to 980F and holds this temperature for 10 minutes. Then
cools at 150F/hour to 670F and shuts off.
2” beads batch annealing Displayed as bd 3
This program heats at 300F/hour to 980F and holds this temperature for 20 minutes. Then
cools at 100F/hour to 670F and shuts off.
Continuous Annealing as you Create Displayed as bd 4**
This program heats rapidly to 960F and holds this temperature for 4 hours. Then rapidly
reheats to 960F to ensure stable annealing temperature and holds for 1 hour. Then cools
at 600F/hour to 400F and shuts off. **This program should only be used in kilns with a properly
installed bead door to „garage‟ hot projects.
Program Rate Temp Hold
Bd 1 500F/hour 980F 00.05
300F/hour 670F 00.00
Bd 2 400F/hour 980F 00.10
150F/hour 670F 00.00
Bd 3 300F/hour 980F 00.20
100F/hour 670F 00.00
Bd 4** FULL 960F 04.00
FULL 960F 01.00
600°/hour 400F 00.00
The preset bead programs can be edited. Each program segment can be changed by the
operator. To restore the factory values, enter a zero value for the first rA1 segment of
each program and press the Program button.
In addition to the bead preset programs, the bEAd mode provides 4 User defined
programs for custom firing schedules. Each user defined program can be up to 8 steps.
The User programs are;
Program Rate Temp Hold___
PrO1 Undefined Undefined Undefined
PrO2 Undefined Undefined Undefined
PrO3 Undefined Undefined Undefined
PrO4 Undefined Undefined Undefined
CLA Program Mode
The CLA mode provides 5 preset firing schedules for metal clay firing and 4
optional User Programs for creating custom firing schedules. The 5 preset
programs are recommended firing schedules that can also be customized if
necessary. These programs provide the various heating steps for easy selection.
PMC+ Fast Displayed as P-FS
To Next Page
Loading...