-90- Program Mode
The 90 COE mode provides 4 preset firing schedules for glass forming and 4 optional
User Programs for creating custom firing schedules. The 4 preset programs are
recommended firing schedules that can also be customized if necessary. These
programs provide the various heating and cooling steps for easy selection.
Full Fuse Displayed as FUSE
This program heats at 300F/hour to 1250F and holds this temperature for 30 minutes.
Then heats at 600F/hour to 1480F and holds this temperature for 10 minutes. Then
cools rapidly to 960F and holds this temperature for 40 minutes. Then cools at
150F/hour to 700F and shuts off.
Tack Fuse Displayed as tAC
This program heats at 300F/hour to 1250F and holds this temperature for 30 minutes.
Then heats at 400F/hour to 1350F and holds this temperature for 10 minutes. Then
cools rapidly to 960F and holds this temperature for 60 minutes. Then cools at
100F/hour to 700F and shuts off.
Slump Displayed as SLP
This program heats at 300F/hour to 1270F and holds this temperature for 15 minutes.
Then cools rapidly to 960F and holds this temperature for 60 minutes. Then cools at
100F/hour to 700F and shuts off.
Fire Polish Displayed as POL
This program heats at 300F/hour to 1180F and holds this temperature for 10 minutes.
Then cools rapidly to 960F and holds this temperature for 60 minutes. Then cools at
100F/hour to 700F and shuts off.
Program Rate Temp Hold
FUSE 300F/hour 1250F 00.30
600F/hour 1480F 00.10
FULL 960F 00.40
150F/hour 700F 00.00
tAC 300F/hour 1250F 00.30
400F/hour 1350F 00.10
FULL 960F 01.00
100F/hour 700F 00.00
SLP 300F/hour 1270F 00.15
FULL 960F 01.00
100F/hour 700F 00.00
POL 300F/hour 1180F 00.10
FULL 960F 01.00
100F/hour 700F 00.00
To Next Page
Loading...
Need help?
General
