This program heats as fast as possible to 1650°F and holds this temperature for
10 minutes.
PMC+ Slow Displayed as P-SL
This program heats at 1500°F/hour to 1470°F and holds this temperature for 30 minutes.
PMC3 Slow Displayed as P3SL
This program heats at 1500°F/hour to 1110°Fand holds this temperature for 45 minutes.
PMC Standard Displayed as Std
This program heats as fast as possible to 1650°F and holds this temperature for 2 hours.
PMC Gold Displayed as GOLd
This program heats as fast as possible to 1290°F and holds this temperature for 90
minutes.
Program Heating Rate Temp Hold
P-FS Full Power 1650F 00.10
P-SL 1500F/hour 1470F 00.30
P3SL 1500F/hour 1110F 00.45
Std Full Power 1650F 02.00
GOLd Full Power 1290F 01.30
The preset metal clay programs can be edited. Each program segment can be changed
by the operator. To restore the factory values, enter a zero value for the first rA1
segment of each program and press the Program button.
In addition to the metal clay preset programs, the CLA mode provides 4 User defined
programs for custom firing schedules. Each user defined program can be up to 8 steps.
The User programs are:
Program Rate Temp Hold ___
PrO1 Undefined Undefined Undefined
PrO2 Undefined Undefined Undefined
PrO3 Undefined Undefined Undefined
PrO4 Undefined Undefined Undefined
User Program Mode
The USr mode provides 6 User Programs for creating custom firing schedules.
You can store/save up to 6 separate custom firing programs in the controller
memory. Each program can be up to 8 Steps long. During programming the
display prompts for the individual firing schedules are PrO1, PrO2, PrO3, PrO4,
PrO5 and PrO6.
Programming Heating and Cooling Rate
To Next Page
Loading...
Need help?
General
