This program heats at 300F/hour to 1165F and holds this temperature for 10
minutes. Then cools rapidly to 960F and holds this temperature for 60 minutes.
Then cools at 100F/hour to 800F and shuts off.
Program Rate Temp Hold
FUSE 300F/hour 1220F 00.30
600F/hour 1465F 00.10
FULL 960F 00.40
100F/hour 800F 00.00
tAC 300F/hour 1250F 00.30
400F/hour 1310F 00.10
FULL 960F 01.00
100F/hour 800F 00.00
SLP 300F/hour 1250F 00.15
FULL 960F 01.00
150F/hour 800F 00.00
POL 300F/hour 1165F 00.10
FULL 960F 01.00
100F/hour 800F 00.00
The preset 96 COE programs can be edited. Each program segment can be
changed by the operator. To restore the factory values, enter a zero value for the
first rA1 segment of each program and press the Program button.
In addition to the 96 COE preset programs, the -96- mode provides 4 User
defined programs for custom firing schedules. Each user defined program can be
up to 8 steps. The User programs are;
Program Rate Temp Hold
PrO1 Undefined Undefined Undefined
PrO2 Undefined Undefined Undefined
PrO3 Undefined Undefined Undefined
PrO4 Undefined Undefined Undefined
bEAd Program Mode
The bEAd mode provides 3 preset firing schedules for bead annealing and 4 optional
User Programs for creating custom firing schedules. The 3 preset programs are
recommended firing schedules that can also be customized if necessary. These programs
provide the various heating and cooling steps for easy selection.
½” beads batch annealing Displayed as bd 1
This program heats at 500F/hour to 980F and holds this temperature for 5 minutes. Then
cools at 300F/hour to 670F and shuts off.
1” beads batch annealing Displayed as bd 2
To Next Page
Loading...