Press (Decrease) button to engage the correct firing program and the LED light beside
“Review” will light up. Additionally, the firing program will begin to display on the LED
display beginning with rA 1. Once the review has been completed, the display will show
Strt.
Press (Program) button and the display will show –On- and begin firing. Note: If you
accidentally selected the wrong program or would like to stop the program, press
(Program) button again and the display will show Stop.
Once the kiln has completed firing, the display will show CPLt and this message will
alternate with the temperature display and the total firing time from start to finish. DO
NOT open the kiln until it has completely cooled and the temperature shows room
temperature.
To Next Page
Loading...
Need help?
General
