DELTA DORE Tybox 1117 - Configuring Your Device (Menu 1); Menu 1-02 Programme Duration; Menu 1-03 Pre-Heat Activation;Deactivation; Menu 1-08 Controlling the Comfort Temperature

5
3. Configuring your device (Menu 1)
Menu 1-02 Programme duration
You can set programming by the hour, half hour, or quarter of an hour.
Default seing: 1 hour.
60 min.
30 min.
15 min.
Menu 1-03 Pre-heat activation/deactivation
Pre-heat means you can enjoy the Comfort temperature you want at the scheduled hour (see § “Pre-heat
function”).
Default seing: Pre-heat o
Pre-heat o
Pre-heat on
Menu 1-08 Controlling the Comfort temperature
For hot water heaters with thermostatic valves, the Comfort temperature can be provided by adjusting the
thermostat on each radiator.
In AUTO mode, the device will show “Conf” during Comfort periods and will be set to constant heating. Only the
Economy and Frost Protection temperatures are controlled by the Tybox.
Default seing: Comfort is controlled by the Tybox.
Comfort controlled by Tybox
Comfort controlled by each radiator
Menu 1-09 Anti-seize activation/deactivation
Anti-seize can be used outside heating periods to regularly start up the circulator during o periods (5 minutes/
week).
Default seing: Anti-seize o
Anti-seize o
Anti-seize on
>5s
2
0
1
0
EXIT
1
2
3
4
5
6
❶ Turn the knob to , then press
the i buon for 5 seconds (❷).
❸ Press the 1 buon.
To change the various seings,
press the + or - buons (❹), then
press OK to conrm the change and
go to the next seing (❺).
❻ To exit the mode, turn the knob.
Menu 1-03 does not appear if the Comfort
temperature is controlled by each radiator
(menu 1-08 = 1).
Menu 1-08 does not appear if pre-heat is
active (1-03 = 1).
Choice 1 turns o pre-heat (1-03 = 0). In this
case, menu 1-03 no longer comes up.