DELTA DORE Tybox 1117 - Configuring Your Device (Menu 2); Menu 2-01 Locking or Unlocking the Settings; Menu 2-02 Correcting the Measured Temperature; Menu 2-04 Temperature Displayed in AUTO Mode (Setpoint or Room)

6
4. Configuring your device (Menu 2)
Menu 2-01 Locking or unlocking the seings
This menu enables you to authorise or lock changes to the seings such as programming or setpoint temperatures.
Locking only applies to seings entered via the Tybox.
Default seing: Changes allowed
Changes authorised
No changes to the programme.
Adjusting setpoint temperature seings.
Menu 2-02 Correcting the measured temperature
This menu is used to correct any dierence you have notcied between the displayed temperature and the
measured temperature.
Example: If the temperature displayed by the device is 19°C and the measured temperature is 20°C, input +1°C then
conrm using OK.
Default seing: 0°C
Adjusts from -5°C to 5°C,
in increments of 0.1°C.
Menu 2-04 Temperature displayed in AUTO mode (setpoint or room)
Default seing: setpoint temperature displayed.
Displays
setpoint temperature
Displays
room temperature
Menu 2-05 12h/24h time and date format
Default seing: 24h
24 h
12 h
Menu 2-06 Automatic summer/winter changeover
Default seing: Automatic changeover
No automatic changeover
Automatic changeover
Adjustment in manual and Comfort mode
limited to between 5°C and 22°C.
Economy seing limited to between 5°C
and 19°C.
Frost protection seing limited to between
5 and 11°C.
In order to change this seing, the unit
must have been running for at least 2 hours
beforehand.
In normal use, press the i buon
to check one or other of the temperatures.
>5s
1
0
1
2
3
4
5
6
EXIT
1
0
❶ Turn the knob to , then press
the i buon for 5 seconds (❷).
❸ Press the 2 buon.
To change the various seings,
press the + or - buons (❹), then
press OK to conrm the change and
go to the next seing (❺).
❻ To exit the mode, turn the knob.