DELTA DORE TYBOX PAC User Manual

TYBOX PAC
User guide
TYBOX
Programmable thermostat for
heat pumps
Because of changes in standards and equipment, the characteristics
given in the text and the illustrations in this document are not binding
unless confirmed by Delta Dore
Device compliant with the requirements of directives:
2004/108/CE (Electromagnetic Compatibility)
and 2006/95/CE (Low-Voltage Safety).
*2702004_rev1*
DELTA DORE - Bonnemain
35270 COMBOURG - FRANCE
E-mail : deltadore@deltadore.com

DELTA DORE TYBOX PAC Specifications

General

Type	Programmable Thermostat
Operating mode	Heating / Cooling
Protection Index	IP30
Weight	120 g
Power supply	230V AC, 50Hz
Setting range	5°C to 30°C
Operating Temperature	0°C to 40°C
Relative Humidity	80% at 25°C (without condensation)

Summary

Warnings

Choosing the HEAT / COOL mode and set-point temperature setting

Choosing the HEAT / COOL mode and set-point temperature setting

Programming

1. Choosing the HEAT / COOL mode

2. Creating your program

3. Confirming and copying the program

4. Confirming the program

5. Checking your program

6. To program the other mode (HEAT/COOL)

7. Exiting the programming mode

Troubleshooting

Nothing is displayed on the room unit screen.

There is no power supply. Check the batteries.

The unit is in time setting mode.

There was no power supply for more than 30 seconds. Set the time.

When setting the time, there is no option to set the day.

You are in daily programming mode. To switch to weekly programming, refer to the installation guide.

When creating a program, the and symbols do not appear on the screen.

Program modification is not allowed. Refer to the installation guide.

The temperature displayed does not match the temperature measured in the room (thermometer)

Refer to the installation guide or contact your installer or our customer service department.

The programs cannot be modified and the set-point temperature settings are limited.

(Heat comfort: 16 to 22°C, Cool comfort: 21 to 27°C Heat economy: 13 to 19°C, Cool economy: 24 to 30°C)

Your heating system is in Frost-Protection mode.

The thermostat is in the , PROG or position.

The indication is displayed.

The batteries are low. Change the batteries, making sure they are the right way round.

The relays do not switch.

You cannot access the cool set-point temperature setting mode.