Chapter 7 Servo Parameters|ASDA-A&A+ Series
Revision April 2009 7-11
Gain and Switch
Control
Mode
Parameter Name Function Default Unit
Pt Pr S T
Related
Section of
User
Manual
P2-00 KPP Proportional Position Loop Gain 35 rad/s
{ {
6.2.8
P2-01 PPR Position Loop Gain Switching Rate 100 %
{ {
---
P2-02 PFG Position Feed Forward Gain 5000
0.0001
{ {
6.2.8
P2-03 PFF
Smooth Constant of Position Feed
Forward Gain
5 ms
{ {
---
P2-04 KVP Proportional Speed Loop Gain 500 rad/s
{ { { {
6.3.6
P2-05 SPR Speed Loop Gain Switching Rate 100 %
{ { { {
---
P2-06 KVI Speed Integral Compensation 100 N/A
{ { { {
6.3.6
P2-07 SFG Speed Feed Forward Gain 0
0.0001
{ { {
6.3.6
P2-26 DST External Anti-Interference Gain 0 0.001
{ { { {
---
P2-27 GCC Gain Switching Control Selection 0 N/A
{ { { {
---
P2-28 GUT Gain Switching Time Constant 10
10ms
{ { { {
---
P2-29 GPE Gain Switching Condition 10000
pulse
Kpps
r/min
{ { { {
---
P2-31■
AUT1
Auto Mode Responsiveness Level
44 N/A
{ { { {
6.3.6
P2-32▲
AUT2
Tuning Mode Selection
0 N/A
{ { { {
6.3.6
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(●) Parameter is effective only after the servo drive is restarted (after switching power off and on).
(■) Parameter setting values are not retained when power is off.
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
