EasyManua.ls Logo

Delta Electronics RTU-EN01

Delta Electronics RTU-EN01
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Modbus TCP Remote I/O Communication Module RTU-EN01
DVP-PLC Operation Manual
3
1 Introduction
To ensure correct installation and operation of RTU-EN01, please read this manual carefully before using your
RTU-EN01. RTU-EN01is an Ethernet remote I/O module for remote setting through Delta’s DCISoft. RTU-EN01
supports maximum 256 digital input/output points. RTU-EN01 supports Modbus TCP protocol and can be used
for remote monitoring with graphic control software or human machine interface. RTU-EN01 can also be used as
a Modbus TCP gateway, supporting the conversion from Modbus TCP commands to Modbus ASCII/RTU. In
addition, in MDI/MDI-X auto-detect, jump wire is not needed when you choose the network cable.
1.1 Features
z Supporting smart PLC functions, counter, timer and real-time clock. Able to operate independently without
control of PLC main processing unit or programming.
z Able to auto-detect 10/100 Mbps transmission speed; MDI/MDI-X auto-detect.
z Supporting maximum 16 digital input/output modules (Max. 256 I/O points) and 8 analog input/output
modules.
z Supporting maximum 16 sets of Modbus TCP connections.
z Supporting Modbus TCP/Modbus gateway (supporting Master mode, connectable to maximum 32 devices).
z Parameters can be set up on webpage.
1.2 Specifications
Ethernet interface
Interface RJ-45 with Auto MDI/MDIX
Transmission method 802.3, 802.3u
Transmission cable Category 5e, 100m (Max)
Transmission speed 10/100 Mbps Auto-Detection
Communication protocol ICMP, IP, TCP, UDP, DHCP, NTP, Modbus TCP, HTTP
Serial communication interface (COM1)
Interface Mini Dim
Transmission method RS-232
Communication speed 19,200 bps
Communication format Stop bit: 1; Parity bit: None; Data bit: 8
Communication protocol Delta Configuration
Transmission cable DVPACAB215 / DVPACAB230 / DVPACAB2A30
Serial communication interface (COM2)
Interface 3 PIN feed-through terminal
Transmission method RS-485
Transmission distance 1,200m
Communication speed
110, 150, 300, 600, 1,200, 2,400, 4,800, 9,600, 19,200, 38,400, 57,600, 115,200
bps
Communication format Stop bit: 1, 2; Parity bit: None, Odd, Even; Data bit: 7, 8
Communication protocol
Modbus ASCIIModbus RTU

Table of Contents

Related product manuals