10
HOW TO LIFT THE MACHINE
IMPORTANT: Take care when you lift the machine. The
planer is very heavy. Use the following directions and a
MINIMUM OF FOUR PEOPLE to place the machine on
the stand.
Fig. 15) between the cuttinghead and the table. Lower the
cuttinghead to touch the 2 x 4's. Use four people, one on
each end of the 2 x 4’s, to move the machine.
Fig. 15
ATTACHING TOP COVER AND DUST HOOD
planer head using three M6 hex head flange screws at
NOTE: The fourth hole is used later when securing cord
to the planer head.
NOTE: Elevation handwheel shown removed to make
top cover assembly easier.
washers. Be sure the top lip of the dust collector rests
on top of the top cover as shown in Fig. 13.
3. Attach top of dust collector to top cover with M5
Phillips head self-tapping screws and M5 washers, at
HOW TO SECURE THE POWER CORD
M6 washers to secure the cord and fasten the left corner
of the top cover to the planer.
Fig. 11
U
V
T
Fig. 12
Fig. 13
X
W
Y
Z
Fig. 14
O
To Next Page
Loading...
