Delta AH Series User Manual

AH Motion Controller – Operation Manual
5-8
_5
9. When the instruction TMR is executed, the specified timer coil is ON and the timer begins to count. As the value of the
timer matches the setting value, the state of the contact is as follows.
Normally open (NO) contact ON
Normally closed (NC) contact OFF
 General-purpose timer
When the instruction TMR is executed, the general-purpose timer begins to count. As the value of the timer matches
the setting value, the output coil is ON.
X0.0
T0(PV)
Y0.0
SV:K100
10 sec
 Accumulative timer
When the instruction TMR is executed, the accumulative timer begins to count. As the value of the timer matches the
setting value, the output coil is ON. As long as users add the letter S in front of the letter T, the timer becomes the
accumulative timer. When the conditional contact is OFF, the value of the accumulative timer is not reset. When the
conditional contact is ON, the timer will count from the current value.

Delta AH Series Specifications

General

Brand	Delta
Model	AH Series
Category	Controller
Language	English