What to do if Delta Power Supply shows DFC_XCH_ERR_NOMEMORY?
If the Delta Power Supply displays the error DFC_XCH_ERR_NOMEMORY, it indicates there is not enough memory space in the controller. Check if the size of the downloaded program exceeds the limit. If it does, reboot the controller.
Why does my Delta Power Supply show DFC_XCH_ERR_PARAMETER?
The DFC_XCH_ERR_PARAMETER error on your Delta Power Supply indicates an incorrect value of dwNum. To resolve this, check if the value of dwNum is bigger than 0.
How to fix DFC_NIBMOV_ERR_PARAMETER on Delta Power Supply?
The DFC_NIBMOV_ERR_PARAMETER error on a Delta Power Supply is due to an incorrect value of wNum. Check if the value of wNum is bigger than 0.
General| Input Voltage | 24 VDC |
|---|---|
| Expansion Modules | Up to 8 modules |
| Series | AX |
| Operating Temperature | 0°C to 55°C |
| CPU | 32-bit |
| Communication Ports | RS-232, RS-485, Ethernet |
| Type | Programmable Logic Controller (PLC) |
| Programming Language | Ladder Diagram |
| I/O Capacity | Up to 256 I/O points |
To Next Page