Chapter 9 Troubleshooting
9-25
Error code Description
CPU
Status
ERROR
16#8236
A CPU parameter downloaded is incorrect. The NTP client service
Continue Keep Keep
16#8240
A CPU parameter downloaded is incorrect. The data exchange by
means of Ethernet is set incorrectly.
Continue Keep Keep
Axes Parameters Data ERROR.
External Gcode Data ERROR.
A module configuration is being scanned.
An I/O module is not configured.(wirte error)
An I/O module does not exist. (wirte error)
An I/O module is not configured. (read error)
An I/O module does not exist. (read error)
The checksum of the module configuration table is incorrect.
The checksum of the module parameter setting is incorrect.
The checksum of the module parameter mapping table is incorrect.
An I/O interrupt number is incorrect.
An I/O interrupt service routine does not exist.
System restoration error.
No memory card exists, or the memory card format is incorrect.
16#9A33
An error occurs when COM1 communicates with slave 19 by
Continue Keep Keep
16#9A34
An error occurs when COM1 communicates with slave 20 by
Continue Keep Keep
16#9A35
An error occurs when COM1 communicates with slave 21 by
Modbus.
Continue Keep Keep
COM1 receives no response from slave 7 by Modbus.
An error occurs when the Modbus connection of COM2 is initialized.
16#9B21
An error occurs when COM2 communicates with slave 1 by
Continue Keep Keep
16#9B22
An error occurs when COM2 communicates with slave 2 by
Continue Keep Keep
16#9B23
An error occurs when COM2 communicates with slave 3 by
Continue Keep Keep
16#9B24
An error occurs when COM2 communicates with slave 4 by
MODBUS.
Continue Keep Keep
To Next Page
Loading...
Need help?
General
