Delta ASD-A2 Series User Manual

ASDA-A2 Chapter 8 Parameters
Revision February, 2017 8-157
P4-18 COF4
Current Detector (W2 Phase) Offset
Adjustment
Address: 0424H
0425H
Operational
Interface：
Panel / Software Communication
Related Section: -
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
0 ~ 32767
Data Size：
16-bit
Format：
Decimal
Settings：
Manually adjust the hardware offset. The adjustment function needs to
be enabled by the setting of parameter P2-08. It is not suggested to
adjust the auxiliary adjustment. This parameter cannot be reset.
P4-19 TIGB
IGBT NTC Adjustment Detection Level
(cannot reset)
Address: 0426H
0427H
Operational
Interface：
Panel / Software Communication
Related Section: -
Default：
Factory default
Control
Mode：
ALL
Unit：
-
Range：
1 ~ 4
Data Size：
16-bit
Format：
Decimal
Settings：
Please cool down the drive to 25 Celsius degree when adjusting

Delta ASD-A2 Series Specifications

General

Control Mode	Position, Speed, Torque
Feedback	Incremental encoder, Absolute encoder
Rated Output Power	0.1 kW to 15 kW
Power Supply	200-230V AC
Communication Interface	RS-485, CANopen
Protection Features	Overload, Overvoltage, Overcurrent, Overheat