Delta CFP2000 Series - Page 264

Chapter 12 Description of Parameter SettingsCFP2000
12.1-00-13
Master Frequency Command Source (HAND)
Default: 0
Settings 0: Digital keypad
1: RS-485 serial communication
2: External analog input (Pr.03-00)
3: External UP/DOWN terminal
6: CANopen communication card
8: Communication card (does not include CANopen card)
 Determines the master frequency source in HAND mode.
Operation Command Source (HAND)
Default: 0
Settings 0: Digital keypad
1: External terminals
2: RS-485 serial communication
3: CANopen communication card
5: Communication card (does not include CANopen card)
 Determines the operation frequency source in HAND mode.
 Use Pr.00-20 and Pr.00-21 to set the frequency source and the operation source in AUTO mode,
and use Pr.00-30 and Pr.00-31 to set the frequency source and operation source in HAND mode.
Select or switch AUTO / HAND mode by using the digital keypad KPC-CC01 or setting the
multi-function input terminal (MI).
 The default for the frequency source or operation source is AUTO mode. It returns to AUTO
mode whenever you cycle the power. If you use a multi-function input terminal to switch AUTO /
HAND mode, the multi-function input terminal has the highest priority. When the external terminal
is OFF, the drive does not accept any operation signal and cannot execute JOG.

Digital Keypad STOP Function
Default: 0
Settings 0: STOP key disable
1: STOP key enable
 This parameter is valid when the digital keypad is not set as the operation command source
(Pr.00-21≠0). When Pr.00-21=0, the STOP key on the digital keypad is not affected by this
parameter.

Display Filter Time (Current)
Default: 0.100
Settings: 0.001–65.535 sec.
 Minimizes the current fluctuation displayed by digital keypad.

Display Filter Time (Keypad)
Default: 0.100
Settings: 0.001–65.535 sec.
 Minimizes the value fluctuation displayed by digital keypad.