Delta CP2000 Series Quick Start Guide

Chapter 3 Set Up the VFD Parameters | CP2000
10
Digital Input / Output Parameters (02) group
Parameter
Display Text
Description of Parameter
Default
Value
Preferred
Value
02-35 External
operation after
reset and activate
Fault Reset OP
When set to 1, the drive
automatically restarts after a
power failure, assuming the
FWD terminal is still closed.
When set to 0, the drive
powers up again and stops,
requiring a cycle of the Start
signal (turn off and then turn
on again) to resume normal
operation (Value 0 is not
recommended).
0
1
Motor Parameters (05) group
Parameter
Display Text
Description of Parameter
Default
Value
Preferred
Value
05-01 Full load
current of motor
Motor 1 Rated
A
This determines the full load
rating of the motor in amps.
None
As stated
on the
motor
nameplate.
05-02 Rated
power of motor
Motor 1 Rated
P
This determines the motor
power in kW.
None
As stated
on the
motor
nameplate.
Note: kW
= HP *
0.746
05-03 RPM of
motor
Motor 1 Rated
This determines the motor’s
60Hz RPM.
1710 RPM.
This is fine
for 4 pole
motors.
As stated
on the
motor
nameplate.
05-04 Number of
poles in motor
Motor 1 Poles
This determines the motor’s
number of poles.
Parameter options:
2 – 3600 RPM
4 – 1800 RPM
6 – 1200 RPM
8 – 900 RPM
4, which is
correct for
~1800 RPM
motors.
RPM value
as stated
on the
motor
nameplate.

Delta CP2000 Series Specifications

General

Output Voltage	0 ~ Input Voltage
Communication Interface	RS-485
Storage Temperature	-20°C to 60°C
Input Voltage	200-240V AC, 380-480V AC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit