Delta CP2000 Series Quick Start Guide

Chapter 3 Set Up the VFD Parameters | CP2000
12
Parameter
Display Text
Description of Parameter
Default
Value
Preferred
Value
07-12 Speed
search on startup
Restart Method
This determines how the
drive starts the motor. This is
a useful setting if the drive
occasionally starts when the
motor is already spinning.
Parameter options:
0 – Disable. Wait for the
motor to stop spinning
before next start.
1 – Speed search, starting
from maximum frequency
(normally 60Hz).
2 – Speed search, starting
from motor start frequency
(normally 0.5Hz).
3 – Speed search, starting
from minimum frequency.
0
3
07-33 Auto
restart internal of
fault (Internal
time counter for
faults)
Reset
RestartCNT
When a restart occurs after
a fault, the drive starts this
internal time clock and
counts the number of faults
that occur within this time
period. If the number of
faults do not exceed the
number recorded in the 07-
11 parameter, the time clock
and fault are reset back to
zero.
When the number of faults
exceed the 07-11 parameter
value, the drive faults and
stops, requiring user
intervention.
60 secs
60 secs
Communication Parameters (09) group
These parameters are only necessary if you are planning to communicate to the built-in BACnet
interface in the drive.
Parameter
Display Text
Description of Parameter
Default
Value
Preferred
Value
09-31 Internal
communication
protocol
COM1 Protocol
Set up the protocol
communication used.
Parameter options:
0 – Modbus
1 – BACnet MS/TP
0
1

Delta CP2000 Series Specifications

General

Output Voltage	0 ~ Input Voltage
Communication Interface	RS-485
Storage Temperature	-20°C to 60°C
Input Voltage	200-240V AC, 380-480V AC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit