3.4 Electrical Installation for AC Wiring
DANGER : ELECTRICAL HAZARD!!
- To avoid shock hazard during cabling, insure any live grid connections are
removed from the inverter.
- Without rain cover or protection, never perform any wiring or maintenance operations
under rainy conditions.
- Before opening the front door, please wipe the inverter case if it is wet to avoid
water seepage.
- Installation for AC terminal must meet the local electrical code.
- Failed to follow the instructions may damage AC cable.
CAUTION : INVERTER AND EQUIPMENT DAMAGE MAY OCCUR !
WARNING !
- Code compliance is the installer's responsibility.
- After the wiring installation, please close the door immediately and fasten the
screws with the torque wrench according to the recommended torque.
- Please make sure the AC cable is longer than 3m.
- In order not to damage the components in the inverter, ensure the correct
conductor is connected to the appropriate AC terminal on the inverter.
CAUTION: WRONG AC WIRING !
DANGER!
- It is forbidden to open both doors at the same time.
30
Installation
To Next Page
Loading...
