5.4.3 Internal Fan 1
Figure 5-18: Internal fan 1 location
Figure 5-17: Remove the internal fan 1 shield cover
* Screw torque required for assembling:
0.8N•m
①
When used, the DC side (right) compartment is provisioned with a single fan
module. (See Figure 5-17, 5-18, 5-19, 5-20)
If the warning "Fan Fail- Internal F00" show on the DSS / APP, please follow
the procedure below to remove Internal Fan 1.
(1) Remove the shield cover.
(2) Loosen two screws shown in Figure 5-18 and remove the fan cabinet.
(3) Disconnect the power connector.
(4) Lift the entire fan assembly from the DC side (right) compartment. (shown in
Figure 5-19)
(5) Clean assembly or replace with a new fan. (shown in Figure 5-20)
(6) Reassemble using a tightening torque of 0.8 N•m.
75
Maintenance
To Next Page
Loading...
